![]() ![]() Although if you prefer to ride a looser (less hold in the waves), smaller fins would be a better option. Generally heavier surfers require larger fins to hold the waves better. Used to increase the strength of a surfboard, a stringer (normally made from wood) runs down the length of a surfboards (typically in the centre of the board from the tip of the nose to the tail).īoards built with Epoxy, Carbon Fibre and soft boards generally don’t have stringers. The nose is the tip of the surfboard, the nose can vary in shapes and size. Basically the thinner the nose the more response the board will perform, while wider noses are better for stabilization. Where the flatter rocker surfboards will be faster, although they will lack the looseness. Generally the more rocker the surfboard has the more loose (manoeuvrable) the surfboard will be. ![]() Professional surfers will tend to go for the thinner boards as they are lighter and offer better performance.The thicker boards are stronger and because there is more foam under the surfer the boards are more stable. The thickness again has a bearing on the board’s performance. ![]() Surfboard thickness is measured from the top deck to the bottom. Generally the wider the surfboard the more stable the board, while a board with smaller width maintains better speed and performance. ![]() The widest point of the surfboard is measured from rail to rail. Choosing the length of the surfboard is dependant on your size (weight, height), board type and waves conditions you wish to use the board for. The length is measured from the nose to the tail. Typically surfboards are measured in inches. THERE ARE MANY ASPECTS TO SURFBOARD SELECTION THESE ARE THE POINTS TO CONSIDER LENGTH This versatile fin material is light, and can be used in a variety of different conditions. The flex pattern in PC fins extends progressively from the base through to the tip, helping the surfer to maintain drive and hold through a turn. Performance Core (PC) fins are made using a multi-layered resin transfer molding process. Ideal for surfers who want a reliable ‘All Round’ fin delivering a combination of speed and maneuverability with flow between turns.Ī wide range of conditions from beach breaks to point breaks.ĭesigned to fit the FCS II Fin System.Well proportioned template with Inside Foil Technology (IFT).Designed for a balance of speed, flow & response.Very affordable yet considered a premium construction due to its high fiberglass content and active flex pattern, these fins will accommodate a wide range of surfers and surfing conditions.Balance of speed, flow and response. Neo Glass fins are precision molded using long strand fiberglass and a marine grade polymer. Powerful, drawn-out turns with added hold. Recommended for boards with deep concaves and moderate-to-extreme rocker.Open face, down-the-line waves, particularly good in point and reef breaks.Ideal for power surfers who like to push hard against their fins and draw out their turns.Elongated template with high degree of sweep provides exceptional hold off the bottom and when carving on the open face.Designed for powerful, drawn-out turns with added hold. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |