I do like having a solid second QB in Superflex leagues, so I grabbed Goff at the 4.10. Fourth through Seventh Picks 4.10: Jared Goff (QB – DET) 5.03: Keenan Allen (WR – LAC) 6.10: JK Dobbins (RB – BAL) 7.03: Dallas Goedert (TE – PHI) My team starts out with Allen, Chubb, and Lamb as my first three picks, and my team is feeling very well-rounded thus far. I think Lamb has the higher upside and more consistent QB play, so that helps break the tie. I just didn’t want to risk watching more RBs go since the first two picks started QB like I did.Ī QB, an RB, and two WRs go on the turn, and I am staring down WRs Lamb and Davante Adams, either of which I’d be fine starting as my WR1. Instead of going with a stud WR or a second QB, I decide to take Chubb here and grab those other positions on the way back next round. This particular simulator seems to favor the RB position a little more than I do, so I might need to react here. No surprise that CMC went at 1.04, but the players after that get a little different. Second and Third-Round Turn 2.10: Nick Chubb (RB – CLE) 3.03: CeeDee Lamb (WR – DAL) In Superflex, I like a starting QB in the early draft spots because it’s such a long time until my next pick, so as awesome as McCaffrey is, I’m going Allen here to anchor my QB position and start my draft right. However, this leaves the stud RB Christian McCaffrey still available along with Allen. They are the consensus top two in most Superflex leagues. It’s not shocking to see Mahomes and Hurts go first and second in this Superflex mock draft. PPR Superflex Mock Draft: Early Draft Position First Round Selection 1.03: Josh Allen (QB – BUF) Draft Targets for Every Round: Early | Middle | Late.Snake Draft Pick Strategy: Early | Middle | Late.Let’s jump in and see how my team comes out! Therefore, my early bench spots can be seen as flex spots for leagues that have more flex slots in the lineups. In mock drafting, flex spots and bench spots are basically the same, especially when you add a Superflex spot. And if your league has been around for a few years, you can even get insights into how your leaguemates draft and make your mock drafts more realistic!įor this particular mock draft, I opted for a PPR Superflex league with 2 RBs, 3 WRs, and 1 TE with no flex spots. You can use the FantasyPros Mock Draft Simulator to draft in your specific league with your specific settings, and it should greatly increase your chances of having a successful draft. It’s redraft season, whether you’re ready for it or not, so that also means it’s time to start mock drafting again! As a dynasty player, I don’t tend to do a lot of redraft mock drafts, but I really think they do help for those particular leagues.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |